Back to previous page Back to Wumpus´s Old Radio World homepage Zurueck zur Vorseite

Tube tester W19

(Last update 10/02/2005)
Wumpus´s Old Radio World Roehren-Pruefer W19

(Letzte Bearbeitung 2.10.2005)
The tube tester W19 of "Funke" disposes of approx. 1200 test - cards. For each tube to be tested, a test card is put on a test array of jacks , arranged in four horizontal rows and 24 vertical columns. Into this matrix of jacks, plugs are pushed where indicated by holes in the selected test card. In this way the required electrical connections for different tubes are made and the functions of the tube are then tested with a 14 - position rotary switch . This tester was perhaps the most used tester in Germany.

(Photos by Rainer Steinfuehr)

Funke W19
Roehren-Pruefgeraet Funke W19. Das Geraet verfuegt ueber ca. 1200 Prüf-Karten. Auf dem Steckfeld (4 Reihen mit jeweils 24 Buchsen) werden die Verbindungen fuer die jeweilige Roehre geschaltet. Mit dem 14 - stufigen Pruef-Schalter werden dann die einzelnen Funktionen getestet. Dieses Geraet ist wohl das am meisten benutzte Geraet in Deutschland.

(Photos von Rainer Steinfuehr)

Test card / Testkarte
Test card size here reduced / Kartengroesse hier reduziert

Funke W19

Test array / Stecker- Testfeld
Test array of jacks / Stecker-Testfeld

Rotary switch / Drehschalter
14 positions rotary switch / 14-Positionen-Drehschalter

Additional to the normal tube tests the following tests and measurements are available:

  • Dial lamp test
  • DC voltage measurement 10 V, 250 V
  • DC measurement 25 mA, 250 mA
  • Characteristic recording
  • Capacitor short cut test
  • Leak current measurement of electrolytic capacitors up to 200 V
  • Line test
  • Fuses test
  • Resistor measurement in 4 areas

Neben den reinen Roehrenpruef-Funktionen konnten auch folgende Messungen und Pruefungen vorgenommen werden:

  • Skalenlampenpruefung
  • Gleichspannungsmessung bis 10 V, 250V
  • Gleichstrommessung 25 mA, 250 mA
  • Kennlinienaufnahme
  • Kondensator-Durchschlagsmessung bis 200 V
  • Leitungspruefung
  • Reststrom-Messung an Elektrolytkondensatoren
  • Sicherungs-Pruefung
  • Widerstands-Messung in 4 Bereichen